Cooling system presure test

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 29, 2003
Threads
39
Messages
220
Location
St. Louis Area
Greetings:

I'm trying to track down a slow coolant leak/loss. I suspect radiator as I have seem some wetness collecting on the sheild under the radiator. I have a presure test kit. My question is how much presure do I put in the system for a proper test and is this the normal operating presure of the cooling system?

Also, I was told that another test with this presure guage would be to run the engine while it is hooked up. A rise in presure beyond normal operating presures may point to a potential head gasket problem. Does this make sense and could this be another diagnostic tool for checking head gasket condition?

Thanks,

Steve
94' 185,000
Original radiator and HG
 
Run the pressure up to the same pressure your cap is rated for (about 15 psi i think)
The tester can be used to check for a blown head gasket by using it just as you said.
You should have an adaptor to test your cap too, just hook the tester on one side and put you cap on the other end of the adaptor. pump it up and see when the pressure bleeds off, if it bleeds off at a lower pressure than it is rated for replace the cap.
 
Back
Top Bottom