coolant plug on the engine block

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 28, 2003
Threads
66
Messages
296
Location
PNW, WA aka wetside
Where can I find the drain plug for the coolant on the engine block? Is it towards the rear of the block on the driver's side? What is it near?
TIA
 
Last edited:
Lower right hand corner. Brass colored. This is on a '77 which should be the same as yours. Don't be surprised if you open it and nothing comes out. They get crudded up.
GL

Ed
2F 016.webp
 
i posted another thread bout the same thing, i took mine off and it was plugged solid in there! i even took out the temp gauge and found no coolant was gettin to the back of the block. still tryin to find out the best way too flush it out?
 
bretty said:
i posted another thread bout the same thing, i took mine off and it was plugged solid in there! i even took out the temp gauge and found no coolant was gettin to the back of the block. still tryin to find out the best way too flush it out?
There are some powerful "uncloggers" out there I think i used the Gunk radiator flush stuff run your cruiser with the stuff in for a few hours then drain
and repeat if necessary
 
Chances are there's just a bit of rust bottlenecked at the drain. Remove the brass plug and the fitting from the engine block then poke around in the hole with a screwdriver. Pretty good odds the rust and a big gush of dirty coolant will spill out.
 
Back
Top Bottom