I have been working on 72 and I have ran into a problem that I cannot seem to remedy. The condenser bolt has apparently rusted itself to the side of the distributor. I cannot get a wrench in to turn it to make sure that it has rusted to this spot. Anyone have any ideas to how to get a wrench on to the nut? Also after taking off the distributor cap the inside of the distributor looks like it has grease inside of it? Is this normal and if so, is there some way to clean this? I'm sorry I am horrible at taking pictures and putting them on here. Thanks to everyone for your help. I want this thing running so bad.
Condensor and Ignition help
- Thread starter KentuckyCats
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Grind the head of bolt off to remove it or spray it and use wd-40 and vise grips. The grease inside may be dielectric grease clean it and re-grease or spray inside with WD-40. If its oil and not grease then it could be O ing for dizzy.
Thanks Bob.
Thanks Bob.