Collector / Y Pipe flanges

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 15, 2006
Threads
80
Messages
2,843
Location
Lincoln, NE
I'm in the process of putting together parts for my SC install. I'm planning to have a custom exhaust done from the stock manifolds back - including the Y connector.

I'm wanting to save my old stock Y pipe as a spare part for my other truck, so if I can avoid cutting it up all the better.

So... Does anyone have a source for the flanges that live on the front end of the Y pipe? From what I can tell, they are 2 of the same flange.

I would like to go stainless ~ 3/8" thick for the flanges.

My initial plan is to weld from those to a 2:1 collector to 2.5" pipe then O2 sensor 1, cat, O2 sensor 2, over frame rail, muffler(s) and then out.

The snag in the plan right now looks like having to either harvest the flanges off of the existing exhaust or from a rig being parted out or have a set made.

I searched a bit, but I didn't see where anyone was making/selling just the Y pipe front flanges. I sourced the O2 sensor bungs (flanges) from Slee.

Thoughts?
 
Well, I have the O2 sensor bungs (Slee), the flanges to connect up to the manifolds (IRBIS), the heat shielding from a '94 to protect over the frame rail (IRBIS) and my factory catalytic converters may be clogged enough to cause back pressure issues.

I have found an exhaust shop that will consider building the custom Y pipe and the rest out of pre-bent stainless custom fitted and welded right using stainless wire and appropriate gasses.

The truck is a 1996 FZJ80 with a TRD blower.

So... the question now is whether to do it in 2.5" with a Magnaflow 94006 and a ??? muffler

or 3" with a ??? converter and a ??? muffler

I searched, but can't seem to find good references to what muffler is right for high flow yet quiet ride.

Is 2.5" adequate or does the supercharger dictate having 3"?
 
Back
Top Bottom