Code 26

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 11, 2005
Threads
4
Messages
9
Location
Memphis TN
I just got home from a trip and my wife tells me that the truck has been running rough and the check engine light is on. I was able to get a code 26. I noticed the coolant was low. I topped up the coolant and the engine ran much better. Cleared the code and took it for a drive. Ran pretty good, no new code but I noticed the oil pressure gauge climbed pretty high when applying throttle. Wondering why coolant was low as well. Engine temp was fine. It is a 94 with 175,000 miles. Thanks for any help and suggestions. In the back of my mind is Head Gasket sure hope not.
 
I'm sure you already knew, code 26 is a rich air-to-fuel ratio code per the FSM. Listed culprits :

- Engine ground bolt loose
- Open E1 circuit
- injector circuit
- injector
- fuel line pressure
- Engine Coolant Temp sensor
- ECM


Hopefully it was the coolant temp sensor just not getting a good reading due to the coolant being low.

Just put a new radiator in my '94 as is was leaking around the upper tank and I needed to top off the coolant every week or so. Hopefully it's something as simple as a loose hose clamp, or nothing at all !!
 
The next obvious cause would be the O2 sensor(s) themselves. My 80 was throwing a 2-6 code when I bought it, then finally a 2-8.

I replaced both sensors (from Cdan) and have'nt seen a CEL since.

Be sure it is not your cooling system first.........the sensors do not like coolant and if you are burning coolant they will need to be replaced anyhow, I have a pretty good hunch that is why mine failed.
 
Last edited:
Thanks, I have not gotten another CEL since topping up coolant. I was just worried as I have not had to add coolant before. I will try and fine where the coolant is going. I have been meaning to change the O2 sensors for a while just have not got around to doing it. Guess it is time to change them out.
 
As I read the FSM, O2 sensors are not listed and a culprit for a code 26. If you have never replaced them, they are probably due, but as I read this, they will not remedy that particular code.
 
I think the "open E1 circuit" is your failed O2 sensor.

When all sensors are functioning = no code

Just about all the codes I am looking at are tripped by either the sensor failing for the relative system, a break in the circuit for the relative system, or a component of the system. The first two would cause the truck to run in an open loop and you would most likely not notice a problem with performance (maybe less than optimum fuel economy)
of course if a component has failed i think you would notice the truck behaving badly. For example a stuck injector would be noticable, engine missing, strong fuel smell, fuel leaking from exhaust manifold if it is stuck open.

I got lucky, mine was throwing a code but still running strong.

Just pointing out that these rigs with 170+k to tend to have the sensor systems failing as often as the system components them selves..............lots of guys driving around with a CEL and no loss of performance.

My .02
 
Just put a new radiator in my '94 as is was leaking around the upper tank and I needed to top off the coolant every week or so. Hopefully it's something as simple as a loose hose clamp, or nothing at all !!

Did you get all the air out of the system.
When I flush the coolant in these inline 6s I like to point the nose of the truck up a steep incline (1.5:1) and shut the truck off for 30 seconds to burp the air from any trapped voids.
Drive home, top up the coolant and mark the overflow bottle when it is at operating temperature.
Should not change for months after that.
 
Back
Top Bottom