Clutch replacement on sm420

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 19, 2006
Threads
5
Messages
9
Location
East Texas
Hey guys, I'm still new here and pretty new at working on my cruiser but I've come to see that this forum is a nice source to make sure I don't blow anything up so here's another project.... I need to replace the clutch, throwout bearing and pressure plate on my FJ40. I've got a 350 in it with and SM-420 and I ordered the new clutch and everything from advanced adapters. I've never replaced a clutch so I'm trying to find some nice step-by-step instructions to go by. If any of you guys know where I can find something like that please lemme know...down time without getting to drive it make me crazy....Living out in East Texas, its a great place to drive it but I just moved out here so I don't know anyone who might coule help. Thanks a lot guys... Patrick
 
Welcome.


Most folks in Texas are at the Roundup this weekend.....wish I was also...you could post something up in chat also about looking for a hand...perhaps someone is still around...


If you have a Toyota service manual or a hanes, the R@R of the trans and tcase is similar...but you will need to support your engine, as the rear engine mount is likley bolted to the rear of the transfer case...take your time and be mindful of what you are doing, and you will be fine. Post up specific questions if/when you run into something!


Good luck!


-Steve
 
Back
Top Bottom