Clutch pressure

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 26, 2005
Threads
171
Messages
3,495
Location
DEN
My cruiser has been sitting a couple of weeks (too hot) and when I got in and pressed the clutch down it felt a lot softer then it used to..I drove around the block and after a couple of shifts the pressure seemed to build back up...I checked the reservoir and it is full..Is fluid maybe getting somewhere where it is not supposed to be (slave cylinder)? I have a new slave ready to install, Is it time to install?? Any tips??

Thanks
 
I would look on the inside of the firewall and make sure that your master is not weeping...

I then would look at the boot around the rod from the slave cylinder, and make sure that is dry also.


If both are dry, I would then bleed the system.

If you find fluid outside a boot, you have a bad component.


Good luck!


-Steve
 
bad news...just replaced slave cylinder...removed old slave...installed new slave...had wife pump clutch a few times..had her push it down one more time while I was under about loosen bleeder ...just before loosening the fluid shot out all around the rubber boot...now I believe the slave is shot..brand new too....:crybaby:

Did I do something wrong to possibly cause the failure...too many pumps?? wrong adjustment on nut??

Thanks
 
Back
Top Bottom