Clutch Fork Boot installation?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 2, 2005
Threads
44
Messages
622
Location
Durango, CO
Website
www.kindel.com
While crawling under my rig I noticed my clutch fork boot was badly deformed and rotting. So I ordered a new one.

Is there any magic to installing it? Will I be able to do it w/out taking the clutch out of the rig?
 
Should be able to remove the slave cylinder and slip the new boot over the exposed part of the fork.
 
Yep, just separate the actuating rod from the clutch fork and slip the boots over the clutch fork (as noted by Lemon, above). It's a little tricky getting it properly seated on the inside. It helps if you drop the clutch cover so that you can work the groove of the rubber boot onto the opening from inside the bellhousing (not absolutely necessary, though).
 
Back
Top Bottom