clogged windshield washer nozzle (front)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 3, 2006
Threads
259
Messages
1,935
Location
Fort Apache: Victoria
Any suggestions on how to unclog one of the hood nozzles? I'm tempted to run a needle into the opening, but I don't want to risk puncturing anything.

The one on the PS works fine. The DS was weak for a few days, and is now completely inoperative. I disconnected the hose and it's fine, so there's something in the actual nozzle.
 
I have used a straight pin. it worked for me!!
 
small stainless or steel wire ~.025" worked for me.
 
Alright then, seems to be unanimous! I'll try it later if it ever stops raining.

Thanks!
 
I just cleaned my rear washer and I pulled it from the rear hatch and used Hot water to loosen all the fluid that had harden from just sitting there. Also, the unions were the same and used a needle and Hot water as well. It work for me and seems just great here with all the snow and road grime.(Thanks Snow Gods for the snow).

P.S. The nozzle can be taken off. There are two tabs on the sides and press them in with a small bladed screwdriver and be sure if you take the unions off, if it has a small BB in it (one way valve) postion it towards the nozzle, if I rember right. Good luck, PM if any ? John
 
Can you just blow high pressure air into the nozzle spray end (backwards flush), with the hose off, or is there anything that will be harmed inside the spray head? I like the idea of taking it off the hood if you can get to it.
 
Back
Top Bottom