Checked out 95...Few issues

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 31, 2005
Threads
123
Messages
628
Location
Vidor, TX DIXIE
I checked out the 95 I was asking about...few problems

Front 2 seats are no bueno.

Spot underneat rear driver taillight was hit, bondo'd and now it rusted through.

Check engine light comes on because of 02 sensor.

clear coat peeling in different places

"Burns" oil...he had it sitting for 2 months and when I checked the dipstick it was LOW---1/4 inch oil showing.

Old oil caked around the spot you put oil into engine around the heads above the belt

Driver door hand is broke but you can manage to get in still

So whats yalls advice on those issues? Its a 95, white, locked, 225k miles, new AC, I drove it all 4wd works and engine feels strong still. Birfields may need to be rebuilt. Steering was tight still too. $3900.
 
Offer $3000 in cash. Not kidding. The oil issue isn't that bad though... mine goes through 2 qts. every 3000 miles, even with 15W-40.


Or go check out the 92. :D
 
$900 more really.... hmm...

He was originally asking 5600. Before seeing it I offered 4000. Now you think a no go unless he goes to 3000? Should I pass this up if I cant get him any lower?

The 92 is unlocked. Still havent seen it's condition. is 2 hours away.
 
He was originally asking 5600. Before seeing it I offered 4000. Now you think a no go unless he goes to 3000? Should I pass this up if I cant get him any lower?

The 92 is unlocked.

Hmm, I must have misread the other thread... I thought he was offering it for $4000...

91-92 never came with factory lockers, that started in 93.

The main things I would be worried about is the rust spot under the tail light and the O2 sensors. Seats, clearcoat, and things like that are no big deal to me, you should see my truck... But, that's just me.

I hope I'm helping out. :)
 
Yes, much help. Honestly, I dont want to be overly excited and jump into something that cant be fixed when I can wait and possibly get something else. My friends own a very reputable body shop and tell me its not much to worry about..as in we can fix it for cost of parts only.

I've been searching about the o2 sensor and cant find information pertaining to my problem. What I know is that the check engine light does not stay on. So that means that the sensor pickin up an error but only so often. So if I brought the truck into Autozone and the check engine light WAS NOT on could it still be diagnosed? Also I'm trying to figure out how hard it is to replace and if the o2 sensor is bad then what has caused that or what can a bad o2 sensor further messed up on the truck?
 
Seats, clearcoat, and things like that are no big deal to me, you should see my truck... But, that's just me.

:)

Yeah thats my feelings too. The front seats will either be bought off another land cruiser or replaced with PRP. No big deal. Again my friend said we could fix the clear coat issue easily. And I understand about your truck, this will be a trail rig and will get some damage.

o2 is what im concerned about mainly because I guess I dont know much about it other than it costs $150 each:frown:

I want to build into a expedition rig and THINK this would be a good platform to start with.
 
My friends own a very reputable body shop and tell me its not much to worry about..as in we can fix it for cost of parts only.

That's always a good thing.


I've been searching about the o2 sensor and cant find information pertaining to my problem. What I know is that the check engine light does not stay on. So that means that the sensor pickin up an error but only so often. So if I brought the truck into Autozone and the check engine light WAS NOT on could it still be diagnosed?

The code is stored in memory. If the CEL is off at the time, you *should* still be able to pull it, IIRC. Don't quote me on that though.

If you were to disconnect the battery or pull the EFI fuse, the code/CEL would be erased. But the truck would have to re-learn everything, and by the time it does, the CEL might come back on.


Also I'm trying to figure out how hard it is to replace and if the o2 sensor is bad then what has caused that or what can a bad o2 sensor further messed up on the truck?

Not much experience there, bud... Sorry.
 
Last edited:
o2 is what im concerned about mainly because I guess I dont know much about it other than it costs $150 each

Amen, bro. My CEL has come on a few times because of them.

I want to build into a expedition rig and THINK this would be a good platform to start with.

The 80-series cruiser was built for that type of stuff. :)

Look for SocalFJ's ROTW, he built one kickass expedition rig.
 
One more thing to look at... Check the label under the hood and see if it says "OBD II COMPLIANT"

1995 cruisers were "OBD 1.5", so to speak, meaning that the standard connector was there, but some of the required sensors and stuff were not. Some 95's were full OBD II compliant though. Rare and coveted.
 
Last edited:
1995 cruisers were "OBD 1.5", so to speak, meaning that the standard connector was there, but some of the required sensors and stuff were not. Some 95's were full OBD II compliant though. Rare and coveted.

Thanks will do when I go check it out again. Maybe tomorrow. In laymans terms....what does all that mean? Why is it coveted, even though I've seen it in topics I still dont know what OBDII means..

I found a useful thread about o2 sensors...seems as though many people replace as PM at 100k miles. I'm sure this truck is well past due. $200-$300 replacement. May try to edge a lil more off the price for that. Apparently the o2 sensor is merely plugged in and replaced.
 
Thanks will do when I go check it out again. Maybe tomorrow. In laymans terms....what does all that mean? Why is it coveted, even though I've seen it in topics I still dont know what OBDII means..

OBD II - On-Board Diagnostics, 2nd generation. It's a standard diagnostics system required on ALL vehicles 1996 and up. Means that if the CEL comes on for any reason, take it to Autozone and have them scan it.

I found a useful thread about o2 sensors...seems as though many people replace as PM at 100k miles. I'm sure this truck is well past due. $200-$300 replacement.
Some people on this board are a little OCD... Quite funny, really. However, aging O2 sensors should be replaced.

Apparently the o2 sensor is merely plugged in and replaced.

Pretty much.. It's a bit of a pain to get those nuts off, though. You know, with the bolts breaking. Generously spray PB Blaster over a few days in advance.
 
mxtaco48 said:
Why is it coveted?

OK, maybe it's not coveted... More like preferred. :doh::D

In emissions-controlled counties, testing stations are required to test all 1996 and up vehicles using the OBD II connection. 1995 and older only need the sniffer. At least that's how it is in UT. So, you'd be using a sniffer on a full OBD II vehicle. Cool, huh?

It's been said before...having a 95 w/OBD II is the best of both worlds.
 
Yeah, on almost all boards I'm on(i currently have a locked, bobbed tacoma) There are those people who are OCD. Whiners in my eyes. People that worry about increasing to 32" tires if they should change gearing(waste o money).

Thanks for the acronym, I was about to check out the newbie thread for it.

I will likely pre order nuts, I always f' up the bolts/nuts when working on my truck....

Thanks for the help. I think I will be ok going with this vehicle.
 
A locked 95' for under $4K?!?!? I can't see any of the "issues" you describe through that crazy low price. I know trucks are cheaper in Texas, but in my neighborhood, that truck has a private party value, in "fair" shape of almost twice your price, retail value is almost $12K. I wouldn't hesitate or one of these hard core guys looking for a truck to cut up might jump all over that thing.

If you are half way decent with a wrench, can figure out how to put on seat covers, and continue to surf Mud, I would say buy it. It's a good deal IMHO.

Good Luck!!
 
Yeah, on almost all boards I'm on(i currently have a locked, bobbed tacoma) There are those people who are OCD. Whiners in my eyes. People that worry about increasing to 32" tires if they should change gearing(waste o money).

Thanks for the acronym, I was about to check out the newbie thread for it.

I will likely pre order nuts, I always f' up the bolts/nuts when working on my truck....

Thanks for the help. I think I will be ok going with this vehicle.

:lol:

No problem. :cheers:



BTW, what year is your Taco?
 
A locked 95' for under $4K?!?!? I can't see any of the "issues" you describe through that crazy low price. I know trucks are cheaper in Texas, but in my neighborhood, that truck has a private party value, in "fair" shape of almost twice your price, retail value is almost $12K. I wouldn't hesitate or one of these hard core guys looking for a truck to cut up might jump all over that thing.

If you are half way decent with a wrench, can figure out how to put on seat covers, and continue to surf Mud, I would say buy it. It's a good deal IMHO.

Good Luck!!

x1,000

Go for it.
 
A locked 95' for under $4K?!?!? I can't see any of the "issues" you describe through that crazy low price. I know trucks are cheaper in Texas, but in my neighborhood, that truck has a private party value, in "fair" shape of almost twice your price, retail value is almost $12K. I wouldn't hesitate or one of these hard core guys looking for a truck to cut up might jump all over that thing.

If you are half way decent with a wrench, can figure out how to put on seat covers, and continue to surf Mud, I would say buy it. It's a good deal IMHO.

Good Luck!!


Haha, thats why I'm not telling where this rig is:D I will however bump the 92 fj80 owner to this site when all is said and done for a quick sell.

And my Tacoma is a 1999 reg cab., locrite front/rr, bobbed 12", SAW c/o's, mx6 shox, 3" BL, 5.29 gears, 33" BFG mt, custom front/rr bumpers n tire rack...I love rock crawling but bought a CBR600rr and no need for the small truck.
 
Back
Top Bottom