Check Engine Light, help needed!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 12, 2007
Threads
30
Messages
207
Location
San Diego, CA
Hello Everyone,
Today while driving on the freeway my CEL came on, went to autozone to get the code and this is what I found, I got P0401 which is EGR insufficient flow, I reseted the code twice but it came back on, does anybody know what i have to replace to get rid of the light and how much should I expect to pay? Any assistance would be greatly appreciated.

Ulyses
 
I wanna apologize, I think I should've mentioned my truck's year, mine is a '97.
I've been reading some of the previous threads about the EGR, I'm supposed to go on a Baja trip tomorrow, I shouldn't have any problems right? also I'm expecting my FSM to arrive some time next week. Does anybody know if a quick fix would be possible, I mean something that I can try right now and is not going to take me the rest of the evening
 
I wanna apologize, I think I should've mentioned my truck's year, mine is a '97.
I've been reading some of the previous threads about the EGR, I'm supposed to go on a Baja trip tomorrow, I shouldn't have any problems right? also I'm expecting my FSM to arrive some time next week. Does anybody know if a quick fix would be possible, I mean something that I can try right now and is not going to take me the rest of the evening

I would not worry about the emission stuff stopping you on a road trip.
 
Although I haven't gone through this yet on my 80, I have dealt with it on my Camry.

I take it step by step, usually in progression from the most cheapest/easiest fix and then to more complicated/expensive fix.

First I'd clean the hoses, EGR, and EGR modulator.
Next I'd fab a new EGR modulator filter (you can't buy just the filter you have to buy the modulator).
After that I'd buy new hoses, a new modulator and then a new EGR if it came down to it.

Face it your our rigs are 10+ years old, you need to start replacing things sooner or later and hoses and emissions stuff are a good way to start.
 
I contacted cdan an this is what he told me,

There are three major components associated with EGR.

EGR valve, list $162.68, net $122.01
Modulator, list $64.05, net $48.04
Vacuum switching valve, list $102.63, net $76.97

No two vehicles appear to fix in the same manner. It could take any one part or some combination of them to include the whole works.

If you do need the valve you will also need a gasket for it and that runs $1.18

I do carry all of it in stock.


I purchased all three parts and replaced them, I haven't seen the check engine light come back on. It's been over 6 months now.
 
Thanks everybody, I really appreciate the help. I'm going to wait until I get my FSM in the mail, then I will proceed to remove, inspect and clean the associated parts, if this doesn't fix the problem I will contact CDan and will get the parts. Once again, thank you everyone.

Ulyses :beer:
 
I would definitely wait until your FSM comes before you start throwing money at it. The FSM has accurate vacuum and diagnostic diagrams which can help you trouble shoot and track down an actual problem without buying everything in the emissions catalog...

That said, if you are in an emissions city/county/state etc., get this taken care of as it will influence your ability to pass emissions for registration.

If you don't, then, personally, I would drive it for a long time without taking care of emissions issues.

But that's just me.....

Good luck.
-onur
 
Back
Top Bottom