center pivot bushing HELP

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 24, 2005
Threads
15
Messages
133
Guys i was goign to replace the bushing in the center pivot. I got the top bit and the bottom screw out andi cant the rest out from the pivot housing . Is there any trick for us the get it out from the housing? Going to register the car tommrow morning so have to get it tommorow morning if not i have to put back everythin

thanks guys
 
Yea im talking about the steering arm just behind the bumper or the bullbar:D. You mean i have to take of the arm at the bottom? the one connected to the toe rod ends?

Now i have taken out the bottom crew and the trhrean on the bolts is sticking out abt 1". So i hit it with a hammer it woulndt budge. I jack it up then the whole freaking car was lifted as well. How am i suppose to take the bushing out
 
Yeah you need a puller. Just get one and pop the arm right off. How the hell else you gonna take it apart? ;p

See the splines in this pic? It's all one piece that's held from coming off by the arm.
pin.webp
 
ok thanks will try tommorow. i remowved the top bits already. its just that stupid cone at the bottom with a thread and screw. unscrewed the top and ottom nut. Got all the rubber bits out pon;y ;eft the cone bits. Hammer it from underneath didnt work and i used a jack to force it out but failes. will try again tommorow.
 
ok got it off w/o taking the arm off using a jack from underneath it and a crow bar to restrain the arm from tilting. another question the top bit where you screw in with a flat top its the snd piece thing that you take off. Before i changed the busdhing it was screw into till the ned of the thread now after i changed in i cant scre it in all the way. Is it supposedly to be like that or wat?
 
Back
Top Bottom