center arm rebuild...one quick question?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 8, 2006
Threads
58
Messages
498
Location
S.E. Tennessee
I have done my search , but cannot find the answer. do I need to replace the felt bushing in the bottom of the housing of the center arm. If so, my kit did not come with one and the original is shredded...what do I relpace it with and where do I find it ...




thanks
Jeff
 
Mine came with one........
coolfj40_1926_8702699.webp
 
center arm felt

Never mind ......:doh: ....I am a dumbass :o the bottom seal in this kit is a rubber/metal ring much like a grease seal for bearings....I openend the kit and just did not see the felt washer....thanks for your time and your reply DEGNOL.


:o :doh: :o :doh: :o :doh:
Jeff
 
I have a rebuild kit and have been trying to get the arm off the shaft. What tool do you use. My pickle fork is too narrow and the pitman arm puller id too thick.

What tool? :mad:
 
Thanks D. I would have done some searching but ... the thread was right there and it was so easy to just ask someone.

I have tried the three arm puller but it kept falling off and yesterday I got the Auto-Zone pitman arm remover but the puller is too thick to go between the center arm housing and the arm. I have propane but no O/A. I'll do some more reading before I attempt again.
 
Kevin, I have found that anything with a taper or taper and splines likes to be put under tension with a puller then tap on the outer "ring" that surrounds the taper. Sideways, not in the direction you necessarily want it to come off. Hard to describe, but it works like a top. I have used a fixed cast two jaw puller that I borrow from a mechanic friend. Looks like the SnapOn that Poser posted a pic of, but is open on both sides so you can tap.

GL

Ed
 
Back
Top Bottom