CEL after birf job??!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 15, 2007
Threads
126
Messages
1,134
Location
Los Angeles
Just got home and finishing a marathon 22 hour day, including birf job and side of highway stop at 2:30am to investigate CEL.

Got a 2 blink 8 blink light. O2 sensor I think. Any ideas? Related to birf job or completely separate items?

Thanks to Boyd and Mkfour for the gear and help to get those birfs done :)

brad
 
Completely separate situation unless you plugged your ABS sensor into the Oxygen sensor's spot!!! :cheers:
 
I think it might be related to either moving wires around. Maybe a short somewhere? On a related note, my 94 had a CEL this summer and found the nuts completely rusted off one of the O2 sensors. At least I didn't have to wrestle with rusted nut :) . Bought an new gasket for 8 bucks and put some new nuts. Chances are you might need new sensors. I changed my 1988 LC at about 190k because of CEL for O2.
 
On your '94 the wiring harness to the O2 sensors runs along the right side front control arm. Check that harness and the connector to the O2 sensor.

-B-
 
Ok, two follow up questions.

1) Is this something that can wait?
2) Is the problem typically with the sensor or with the wiring?

I dont have the time to do this one myself, so I'm trying to load my mechanic with info tomorrow morning.

This car is turning into a full time occupation :frown:
 
yes ,it is something that can wait especially if your truck doesn't run rough or the MPG goes down.
it's more typical with the sensor but since you've been messing in that area maybe the wiring.
How many miles on the truck?Does the CEL go out when you shut off the engine and restart? If it does go off what speeds and/or duration does it reappear?
 
yes ,it is something that can wait especially if your truck doesn't run rough or the MPG goes down.
it's more typical with the sensor but since you've been messing in that area maybe the wiring.
How many miles on the truck?Does the CEL go out when you shut off the engine and restart? If it does go off what speeds and/or duration does it reappear?

No rough running, though maybe this is related to the occasional low(375-400rpm) idle I have? MPG is not defined yet since I just got the truck. I think its going to be low though, 9.5 mpg on my first half tank refill of city driving.

Just under 94,000 miles. CEL stays on. It came on within about 2-3 minutes after getting up to 65-70 mph on the freeway. The only other thing I did, beside the front axle service, was to add some h2o to the coolant overflow.
 
The CEL for O2 sensors should not stay on after shutting off the engine and restarting from my experience. Both my 88 and 94 LC CEL codes for O2 only went on after warm up . I think it is wiring related. Double check that 28 is for O2 sensors because I thought it was 24,25, or 26.
Was fluid spilled on any wire harness after the coolant refill?
 
Back
Top Bottom