CDL switch in... nothin.' (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

The click is the relay box where the pin7 mod is done in the left kick panel. If the locker motor is not running it's ether a bad motor or it's not getting power from the relay. The FSM has the troubleshooting procedure. I am in that boat and haven't had time to troubleshoot. :frown:
 
IXXI

I used a 1-1/16" box end, I don't know the metric equivalent off the top of my head. Once removed use an Ohm meter to check continuity between the pins when actuated. If none, smack it lightly a few times on a hard object then retest. If still no continuity replace switch. If tests good reinstall snug, add new switch on list for Dan (it will fail again).

Kris
 

Users who are viewing this thread

Back
Top Bottom