CDL is very finicky.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 11, 2008
Threads
9
Messages
50
Location
Montukey
I searched FAQ and archives to the best of my abilities, but to no avail. I am new to this so here is a little intro. My name is Derek, I currently live outside Bellingham Wa, and I recently purchased a 97 LX450 (locked) w/140k.
Prior to CDL swich, it went into 4L (locked) w/out issues, but engaging front and rear required reversing a little, and or driving forward a ways. Disengaging usualy required similar steps.
With the newly installed CDL switch, thins are very much the same, however When I activated the CDL switch today, nothing happened. I tried it several times and nothing. After getting back from Sears (needed 24ml socket for the diffs, could not find 6pt.) I tried again and it worked. Front and rear lockers still required the forward and reverse steps.
I guess my qustion is--
#1 Is something wrong with the lockers? Or is this fairly normal?

#2 Am I possibly leaving tension on the system by not disengaging properly?

#3 What is up with this infatuation? Ever since I got her in the driveway, every spare second and every spare penny has been consumed. Me thinks I'm sick.

#4 Any Bellingham Wa area enthusiasts care to kick some rubber?;)
 
Welcome :flipoff2:

I will try and help out but no promises:D

It is normal for the lockers to take longer to engage/disengage if they havent been used much... Turning while engaging usually helps more than just traveling a straight line.

Also I just want to clarify with the cdl/pin 7 mod your lockers will only engage when the cdl is engaged regardless of high or low range...

Dont worry its normal:hhmm: I believe to be infatuated with your new cruiser I still am :doh:

Post up a pic so we can see the jewel!

Jason
 
Back
Top Bottom