Hey Guys,
I am going to have my bushings pressed on Wed. I am going to take off my control arms and take them in to a shop to press them..
I am not sure how to mark the control arms so they get pressed properly, or how to make a jig. Can you please inform me as to how I should mark the control arms, and give me some ideas on how to make a jig. I have seen a jig simply made from a 2x6 board and a couple of holes drilled... this seems like a fairly simple, but are there some specs that I need to pay attention to when making my jig/getting bushing pressed.
Lastly i tried to search, but found WAY too much to read through to sink into my head.
Sorry to bring this up again, but thanks,
I am going to have my bushings pressed on Wed. I am going to take off my control arms and take them in to a shop to press them..
I am not sure how to mark the control arms so they get pressed properly, or how to make a jig. Can you please inform me as to how I should mark the control arms, and give me some ideas on how to make a jig. I have seen a jig simply made from a 2x6 board and a couple of holes drilled... this seems like a fairly simple, but are there some specs that I need to pay attention to when making my jig/getting bushing pressed.
Lastly i tried to search, but found WAY too much to read through to sink into my head.
Sorry to bring this up again, but thanks,