castle nuts on tie rods

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 4, 2006
Threads
636
Messages
23,860
Location
Buckley, WA
What do we torque the castle nuts down to on the relay rod/tie rod.
I can't find my FSM anywhere right now.
 
not sure if its the same on 80's but my fsm for my 62 calls for 67 ft-lb
 
not sure if its the same on 80's but my fsm for my 62 calls for 67 ft-lb

Yeah I just found my FSM and it's the same
Thanks Josh :cheers:
 
Yup, I tighten to spec, then just a little more if I need the pin to fit.

I bent my nuts beating on them during the dis-assembly process. I got them cheaper from Toyota than a local ACE hardware. Not only were they cheaper by about a dollar they looked like higher quality and came with a new pin!
 
Back
Top Bottom