Carburetor Insulator

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 14, 2019
Threads
3
Messages
7
Location
Central Coast Cali
Gents,

The bonded black gasket on my carburetor insulator had some chunks missing out of it so I removed it on both sides. As this caused a nick or two on the insulator, I resurfaced both sides on my mill, and it came out quite nice.

Now what? I have the upper and lower gaskets...the greenish looking ones that SOR sells...can I just bolt it up using them? Or do I need to make a couple new gaskets out of some specific type of gasket material?

Thanks in advance for your replies.

Justin
04/74 FJ40
 
Going by posts in the past I think more folks than myself didn’t realize the bonded gaskets aren’t made to removed, until the damage was done. I recall the advice was to just get it flat and use gaskets. A belt sander was all I had available and it’s been working fine since 2000.

I think it’s personal preference about sealants on gaskets or whether or not to use anything. Some of the preferences I’ve heard of here are, dry, a little oil or some high temp sealant on one or both sides. I’ve always been a Never-Seize fan on almost all my gaskets but on a tip here I’ve been using Syl-Glyde for a few years and really like it.

I’d like to see a pic of your machine work on the insulator. I’ve always wondered if there were fibers in the composition and if fuzzies would get left. I also wondered if there was asbestos in the bonded-on gaskets or the insulator itself.
 
Going by posts in the past I think more folks than myself didn’t realize the bonded gaskets aren’t made to removed, until the damage was done. I recall the advice was to just get it flat and use gaskets. A belt sander was all I had available and it’s been working fine since 2000.

I think it’s personal preference about sealants on gaskets or whether or not to use anything. Some of the preferences I’ve heard of here are, dry, a little oil or some high temp sealant on one or both sides. I’ve always been a Never-Seize fan on almost all my gaskets but on a tip here I’ve been using Syl-Glyde for a few years and really like it.

I’d like to see a pic of your machine work on the insulator. I’ve always wondered if there were fibers in the composition and if fuzzies would get left. I also wondered if there was asbestos in the bonded-on gaskets or the insulator itself.

Steamer,

No fuzzies on the insulator after machining...it came out smoother than a babies behind. I fly-cut it using a sharp, brazed carbide bit with a nice little radius at 2720 rpm's.

I hope there wasn't any asbestos in it, as it the cutting produced a fine yellow dust. I had my shop vac running with the hose next to the vice the whole time.

I'm not sure of the material...kind of a mottled brownish- yellow in color. Maybe a Garolite?

Justin
20190719_095904.webp
 
Nice job & thanks for the pic.
 
Back
Top Bottom