Carb problems persist with Rochester

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 10, 2004
Threads
214
Messages
847
OK- in 2003 I asked several questions about my rochester 2bbl before rebuilding it and getting a few months of decent use maybe 500 miles on it. Now this thing won't idle again. The idle adjustement screw keeps gettign backed out. I have readjusted it about ten times. It also runs very very rich and the inside of the carb is full of black.

Is there maybe something I am missing?

I just want a carb that is reliable and clean running.

What are my bolt on cost options for a Aisin (non USA)?

Thanks


Aaron
 
Yeah, sheit-can old 'Chester. I got my NIB nonUSA from SOR, way back when, but I'll bet you can get a better deal somewhere. Maybe contact CDan, or FJJim.
 
new spring time on the idle screw, sounds like its not putting enough tension to keep it there,

also a washer spacing the worn out spring, or a nut to lock it there, just a few easy fixes.
 
I used to have an old rochester on mine, they were originally sold as a kit from Man-a fre in the 80's before they switched to the weber set-up. I have now gone weber which was a cheaper option than going back to the aisin, although I hear a non-usa aisin on a desmogged rig with a non-usa dizzy is a sweet set-up. As far as your rochester, like the guys above said, pick up a new spring for the mixture screw. Where inside the carb is it black? If its in the barrel and not in the float bowl, you are probably backfiring through the carb and that is a symptom of timing/ignition problems vs the carb itself. When you rebuilt it, did you get the float settings and choke setings correct? The rochester has a manual choke so if it is not returning correctly, the thing will over-fuel like a champion. If you determine that these things, timing, choke, and float blowl height, and the mixture is set correctly, you may want to go down a couple of sizes on the jets.. mine overfueled pretty badly as well before i swapped the chester out. I still have the instriuctions from man-a-fre for setting the unit up if you need them. When they are working right, they are not bad carbs and very field serviceable as they are so damn simple.

Mike
 
Thanks

Mike- thanks for the offer, I would love those instructions. thanks.

As far as those thigns you mentioned that will take me some time tomorrow to mess with. It sounds like you know much more than I do. The open topped area gets black not inside the float. This area is thr area you see when you take the aircleaner off and look at the top of the carb, soot and crap.

This was one of the MANAFRE deals.

Q- What does this cost "non-usa aisin on a desmogged rig with a non-usa dizzy" ballpark? How do I tell if my distributor is right?

Q- When you rebuilt it, did you get the float settings and choke setings correct?
A- my buddy is a very good LC mechanic and he confirmed it is/was done right.

thanks

Aaron
 
Back
Top Bottom