Carb issues, I think?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 16, 2019
Threads
36
Messages
82
Location
Defiance Mo
Just got done battling with a new clutch in a 72 fj40. Of course I dropped the tranny and transfer case. Didn't rebuilt but replaced seals and gaskets. I got to say I am very happy that i have no leaks. I have a 350 gm with a holly truck avenger carb. I rebuilt the carb a yr ago and barely has any miles on it. I was testing out the 4 wheel drive after driving it around for about 10 miles in 2 wheel. About 10 seconds of rolling in 4 high the engine just bogged down and died. I like to idle low but not to low but not sure if the torque on the engine in 4 wheel was to much and i should increase the idle. I have always heard the 350 swap should run a little high anyways. Dont ask where i heard that I could of dreamed it also. Has anybody else experienced this?

Side note ? I have always found it tough to shift in and out of 4 wheel drive and can only shift it if the truck is in the right place. either rolling forward or back and finding the sweet spot i call it. Just frustrating and wondering if its me or the truck or both or i just have a POS
 
Back
Top Bottom