I finished installing a redark trailer brake controller today and unfortunately found that the previous owner really did a lot of hacking into the wiring near the trailer brake controller plug on my 2019 Land Cruiser.
There’s about 10 T-style wire tap connectors going to a bunch of different wires. Two of the wires go down to a small button screwed into the lower dash panel. I entered the pictures into AI and I told me it’s likely some sort of “valet” mode button.
Has anyone seen one of these before or have any idea where I could find a wiring diagram, manufacturer, or some sort of installation instructions? I’m scared to death to push that button because I don’t know what it’ll do so I just left everything in place. I would like to remove it and get rid of the t-taps to avoid a potential issue down the road, but that’s not something I’m willing to do with guess work at this point.
There’s about 10 T-style wire tap connectors going to a bunch of different wires. Two of the wires go down to a small button screwed into the lower dash panel. I entered the pictures into AI and I told me it’s likely some sort of “valet” mode button.
Has anyone seen one of these before or have any idea where I could find a wiring diagram, manufacturer, or some sort of installation instructions? I’m scared to death to push that button because I don’t know what it’ll do so I just left everything in place. I would like to remove it and get rid of the t-taps to avoid a potential issue down the road, but that’s not something I’m willing to do with guess work at this point.
