Bump stop problems...

[_Mitcho_]

hey guys
ive got a 4" lift and 38.5" tyres on my cruiser. I have to extend the bump stops so the tyres dont rub my guards, the back is fine but the front is my problem.

I flexed it up with a forklift and the bump stop needed to be 230mm from chassis to diff housing but when the car is flat on the ground there is only 260mm between the chassis and diff. im affraid if i make them 230mm ill hit the bump stops just going over small bumps etc.. Im not sure what i should do so any advise would be great.

thanks Mitch

 

[js93cruiser]

Bigger lift, or start cutting

 

[IBCRUSN]

lol....sawsall

Seriously though, either one of these type designs should fit the bill. Fab or source locally.

https://forum.ih8mud.com/attachment.php?attachmentid=278095&stc=1&d=1227914828

 

[_Mitcho_]

thanks guys! ill see what i can do!

 

[phatman81]

I'm looking at King Air Bump Stops .. Softer controlled bumps without the harsh rebound issues ..

 

[megolfer]

Delta vs makes these also

 

[megolfer]

I dont have any close pics of the front bump stops