Broken???

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 19, 2004
Threads
5
Messages
14
At the risk of asking a relatively basic question,….
I was out rattling around the back roads yesterday and started losing brakes. I stopped, found out where the leak was coming from (pinched front right interior hard-line) and noticed the front anti-sway bar was loose. Turns out the passenger side mount above the control arm isn’t fastened to anything. Apparently, the anti-sway bar shifted in compression and pinched the short section of hard-line on the inside of the knuckle. Has anyone ever experienced this before? I was surprised that anti-sway bar mount on the axle side didn’t have a bolt (neither side), is it supposed to be welded? If so, how could that have sheered off?
 
Picture(s)?
 
Pics for IronWagon

Here's the description from IronWagon:

1st Pic - Shows the affected brake line. the pinch occurred at the fitting on the left (in front of the shock and where the rust is), I straightened it and was able to keep enough fluid in to get me home.

2nd Pic - Is a ground up view of the passenger side mount. You can see the control arm in the fore ground. I originally assumed the hole was for a bolt; however I guess it's just used for a centering pin, but that's a total guess.

3rd Pic - Is a top down view. Notice how the bracket on the anti-sway bar has slid forward on the control arm mounting surface. I checked for welds and didn't really see any, but looking at the picture there may be one on the front side (?).

Picture 002.webp
Picture 003.webp
Picture 004.webp
 
Thanks for the diagnosis. I'll get things put abck together this week.

I'm still surprised Toyota welded that bracket, and from what I can tell only one weld in the front.

Thanks again.
 
Let us know how it turns out (maybe even some pics of the repaired parts).;)
 
Back
Top Bottom