brake switch location

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 22, 2008
Threads
89
Messages
1,756
Location
Florence, SC
I know this might seem like the newb question of the century....but.....I'm starting to tackle the painless wiring harness today and don't know where the brake switch is....there are no pedals installed (clutch,brake,gas) so Im not sure where the switch would go....It may not even be installed...? 65 fj40...thanks...:o
 
Hope this helps


The pedal bucket is welded to your fire wall look for the tab with threaded nut
P1010010-2.jpg
 
And here's another picture just to be sure:

brake1.webp
brake1.webp
 
I now have a switch but since I dont have a 65 wiring diagram yet I'm not sure where I need to route the 4 wires from the switch to my painless harness....
Other than connecting current for the brake lights when the brake is depressed is there any other purpose of the brake switch?

BTW the switch I have has 2 green wires coming out the end then 1 red wire on each side...for a total of 4 wires....
 
Back
Top Bottom