Brake line hose

[webbz47]

As I was taking apart the front hub on my 87' BJ70 for an inner axle seal replacement I broke off the brake line where it connects into the dust plate. Does anyone know of a good replacement? The old brake line hose looked kind of hard anyways.

 

[roscoFJ73]

Have a look at a 60 series brake line.As long as the length is ok,the fittings will be the same. Lots of 60 series parts are interchangable.

 

[webbz47]

I was wondering if there was a common replacement hose people use to bypass the connection on the dust plate. Not sure why its connected to the dust plate other than to give stability.

 

[webbz47]

Does anyone know where I can purchase the following brake lines?

47315-60321 (Right)
47314-60161 (Left)

They are the solid lines on each front side that connect to the flexible lines.
Mine were seized and I was unable to disconnect without damaging them.

thanks.

 

[Whistler74]

Did you try Toyota? Otherwise, I'm sure you could get through Steve at EBI, or order through Mustang Connection.

Good luck

 

[webbz47]

Just got a call back from Toyota and they're able to source out of California. All I need to do know is remove the part of the brake line that's stuck inside the connector on the rear of the dust plate. Funny how one job becomes another