Is there any way to get all of the fluid out of the reservoir? it gravity bled to 1/2 way.
Thanks
Thanks
brake fluid flush 15LC
- Thread starter kng
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Taco2Cruiser
Crazy American Off Road
Unless you want to remove the master cylinder and bench bleed it, then no. But you can get a very good amount of it out, then after enough filling with fresh fluid, will be diluted to almost new.
Never let an air bumble get sucked into the tubes at the bottom of the reservoir, because then you’re doing that remove the master cylinder from the truck to bleed the air bubbles out of it thing to get your brake working again.
I’ve gotten lucky only an handful of times fixing customers that did this to their cars, but many more times, I just had to remove the MC.
Never let an air bumble get sucked into the tubes at the bottom of the reservoir, because then you’re doing that remove the master cylinder from the truck to bleed the air bubbles out of it thing to get your brake working again.
I’ve gotten lucky only an handful of times fixing customers that did this to their cars, but many more times, I just had to remove the MC.
- Thread starter
- #3
thanks taco2cruiser.
we depressurised the accumulator with 40 pumps the turned ignition on to pressure bleed the rear. next we
did a lot of manual beeding of the front calipers and ran out of time. i just refilled about 1/2 with new fluild. it looks
like i need to to that a couple of more times.
we depressurised the accumulator with 40 pumps the turned ignition on to pressure bleed the rear. next we
did a lot of manual beeding of the front calipers and ran out of time. i just refilled about 1/2 with new fluild. it looks
like i need to to that a couple of more times.