Blower Speed Control Relay

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 1, 2004
Threads
245
Messages
3,540
Location
Staunton, VA
Per the FSM, but I have heard it called the blower resistor, blower speed resistor, blower motor resistor, etc. From what I have gathered the different fan speeds for climate control are controlled by a relay/resistor behind the glovebox. The first three speeds low, med-low, and med-hi are controlled by a resistor and the hi fan speed just gets straight 12 volts.

My fan only blows on the high setting so I am assuming it has to do with the relay/resistor whatever you want to call it. My question is how do I get this thing out? I can get my hand around it but for the life of me I can't figure out how it's attached and I don't want to break anything.

The picture below is the page from the FSM. The relay is behind the ECM attached to the back of that big gray box (I have no idea what it's called).

2ziaqh1.jpg
 
There are two relays or whatever they are called that run the fan.
There is one in the driver kick and one behind the glove box.
When you have the keys turned to the power on position and start pressing the fan buttons you should hear the relay in the driver kick and the one behind the glove box clicking when you press the buttons.
The one behind the kick is easy.
I had to mess with the one up in the dash, it is not fun.
You need to take a bunch of stuff out to get to it.
The relay is up above and behind what I belive to be the blower and the ac condensing unit in the dash.
I did not want to deal with disconecting any ac lines so I left the condensing unit it in there which made the relay hard to get at.
It will take you a few hours to get the unit out and alot of cuss words.
Once I got mine out I did not even bother to try and out it back where it was I just reconnected the wires and stuffed it up in the dash.
Once you take the glove box out you will see what you have to remove ie ECU, some other control boxes and such and you will have to reach up in to the dash to locate it.
Good luck it was a PITA.
 
Yeah, I had all that stuff out. How is the relay attached to the condenser housing? I had my hand on it, but I didn't want to just rip it off. You'd think with all that space up in there Toyota could have found a more handy spot to put it.
 
It is attahced by some type of clip.
It is a real PITA.
I cannot remember if I just broke the clip or not.
 
Yes I just pulled it off, it has been awhile.
It is clipped in there somehow I cannot remember.
There is no room in there to move is the problem.
 
The clip is on the left of the relay. I couldn't get to it because of the space. I just ripped it off. It didn't hurt the housing.
 
Back
Top Bottom