Blower fan question...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 16, 2003
Threads
201
Messages
615
Note attached pic (thanks SOR)...part #12...

My orginal piece appears to simply be just plastic grillwork (about a 1" mesh). Is there suppose to be a finer mesh screen of some sort as part of this? Seems some large bugs, etc. could come thru the louvers and into the ductwork to set up housekeeping. Any thoughts?

Thanks

Dave
blower.gif
 
I think the grate us more to keep someone’s fingers out of the fan. The flap changes the fan intake from outside to inside. If the flap is closed bugs could fly from the inside into the fan and out through the vent in the heater. Just leave the flap fully open or fully closed. Besides, there are usually plenty of other places where they'll crawl in. ;)
 
Thanks all who replied...

The question was primarily aimed at determining if there was orginally something else there in addition to the plastic grate. The project is not a purists' restoration, but when possible, I am trying to keep things as orginal as possible despite the Aqualu tub and cowl.

Cheers and Keep on Cruising!

Dave
 
I kinda wish that there was a gasket between the fan housing at the side of the apron so that fresh outside air could be drawn in. Apparently, Toyota never made a gasket for this purpose.
 
gasket

Doug,

My blower box "intake" did have a factory foam seal which the small ductwork leading to the louver would set against. Two blowers I've dismantled for pieces and restore did have this foam...
 
i was wondering the same thing ? i just purchased that piece ( #12 ) from SOR and thought it would come with a screen of some sort ? and the blower box i had use to have a piece of foam too. so i just got some foam and cut it to fit and rubber cemented it to the box and it works pretty good. hardly any hot engine compartment air getting in now.
 
There was not anything other than that plastic grate affair at the inlet to the heater.....Earlier years were metal Pre 1973, iirc., and later ones were the plastic style.


There should be a foam gasket/seal in some deteriorated state between the blower motor box and the inlet grate.


:beer:
 
Thanks Poser...
 
Back
Top Bottom