block heater question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 14, 2005
Threads
35
Messages
177
Location
Edmond, OK
I just picked up a block heater for my 94 and was wondering how much coolant will I lose if I try to remove the freeze plug from my engine without draining the coolant? Is there an easy way to get the plug out?

Grand
 
You will lose all your coolant. For the couple of minutes it take. Drain the system, pop out the plug (hammer and punch, knock sideways, then vise grips to pull out) Flush the system, before and after putting the block heater in, then fresh coolant and away you go.

Cheers
mike
 
When I did mine I left the coolant in figuring it might help wash out any junk I knocked into the system while removing the freeze plug. If your block has some rust on the on the outer face of the freeze plug opening make sure you smooth it out with sandpaper of a file before installing the block heater. I didn't and my block heater leaked a bit. Do the sanding before you remove the plug too.
 
You'll lose some, but not very much. If you simply look at the height of the freeze plugs versus the height of the remaining block and radiator it would probably be closer to half.

DougM
 
Back
Top Bottom