bj 40 frame mounts

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I could get some at the wrecker when I'm out there next. How soon do you need them?
 
cruiser guy i would like a pair also. what mount do i need for transmission? i will run my 79 fj40 4 speed with input shaft changed with one from a 3b.
 
nmbuckaroo said:
what mount do i need for transmission? i will run my 79 fj40 4 speed with input shaft changed with one from a 3b.
Click to expand...

The "B" series rear mount was beneath the bellhousing and the bellhousing had a set of bosses for the mount which the early "F" series cruisers did not have.

I'll see what I can do for getting to the wreckers but don't hold your breath. I have to fly up to Canada in a week or so. The tranny mount was hard to find for my FJ45LV a year or so ago so it will be even harder now!
 
cruiser guy are you going to wrecker in guatamala or canada.
 
ok. if you find time i would like to get the parts.
 
sorry for hijack. i will be second in line after fj40moneypit.
 
I know they are there (there was several BJ40's there last time I was there) it's just a matter of me getting out there. I have to fly to Canada for surgery next week so if I don't get there before then I can always go afterwards when I get back.

How soon do you need these? What about the rubber mounts? Tranny mount (doubtful, they usually get dumped with a clutch swap and replaced with a 2x4!!).
 
If they have the rubber mounts that are any good get them too. if there is a crossmember that has 'L' style brackets on each side those would be good too.
I can wait there is no problem with that. I will send you a PM with my email address and other questions.
 
You must log in or register to reply here.

Share this page

Back
Top Bottom