Birf/Axle size variations

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 1, 2008
Threads
84
Messages
558
Location
Burbank, CA
Hey Guys,

Im looking to pick up a set of birfs, axles and drive plates(drive flange?) off a 92 FJ80.

I will be using them as trail spares for my 94 80. From what I remember Cdan telling me, Toyota changed the birf lenghts in April of 94. My car is a 11/93 build, so I think I have the shorter style.

My question is, will the ones from the 92 fit without any issues ?


Thanks,


Harry
 
I'm pretty sure they should fit. I had my PS birf/axle replaced in my 92, with the original earlier style birf. A few months later I did my front end rebuild and used the later model, longer birf, with the longer style drive flange on the DS. You just have to make sure you have the right drive flanges
 
Just making sure, thanks.
 
I think the whole process is pretty easy, but if you haven't done a lot of wrenching it could be a big PITA. There is a great write-up of the whole procedure in the FAQ, under front-end rebuild, with pictures and such. You don't have to rebuild the whole front end to replace the birfs, but usually you should if your birfs need replacing. Use the search option and look for "front end rebuild", or search through the FAQ. Good luck
 
Back
Top Bottom