Bed replacement HELP!!!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 4, 2006
Threads
99
Messages
1,570
I have some rust holes in my bed area of my fj40. Anyone have an easy inexpensive way to fix this. Is it better to cut the bed out and replace the rusted bed or to put a piece of steel bed over the rusted bed and weld it in. I do plan on beed blasting the bed and putting a rust prevenitive down before I cover this up. HELP!!
 
Toyo FJ40 said:
If it's just holes I'd cut them out and weld in patches. I wouldn't cover it up because the rust would build up between the two layers faster than if you only had the one.
i will second this...i have seen it done and if done properly looks REAL nice and holds up for quite awhile.
 
Like others have said ... just don't cover it up.

If you do opt for a replacement don't use flat steel. It will rattle and drive you nuts.

I ended up replacing the entire bed but rather than use one of the CCoT expensive replacement beds I cut one from a junked pickup truck.
 
Back
Top Bottom