bed-lining interior questions

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 23, 2008
Threads
39
Messages
571
Location
Finger Lakes NY
I want to bed-line the interior of my 80 and want to know what you guys have done with the wiring that runs on the floor to the rear of the truck: encase the wire in the liner, or tin covering it, or what?.
I don't like the idea of having the wires exposed.
Any help or pictures would be greatly appreciated.
 
Hi Beno -
I saw your thread a few days ago and it got me thinking about the finish product. Your last picture looks like that's not the last step(?). Did you do anything to further cover or protect the wiring harness than just the conduit it's already in?
Thanks for your reply
Joe
 
Pull it out of the way, spray, then put it back where it was.


I understand how its done... So are you just driving around with an exposed harness on the floor, even under the rug there is a clear peice of plastic covering it. After years of grinding dirt into the rug under my feet the harness and the valley it sits in were full of s***. I'm doing a body swap(future thread), and its getting lined, just don't the idea of an exposed harness on my floor. :cheers:
 
It's in the factory wiring loom, but yes...just exposed. It's not in the way, as it always sits in the channel with the drain plugs. It wont get damaged with the loom on it. And if you do any more to protect the wiring you'll start blocking off drain plugs.

Without the carpet you can easily just run a shop vac over the channel and suck everything out. I also like not having to try to get to the wiring there...wish the whole cruiser could be that easy.
 
Back
Top Bottom