backing plate question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 6, 2009
Threads
32
Messages
150
Location
Belmont, NC
I'm just wondering if anyone knows of a problem that i'll run into by swapping my rear axle backing plates (yes, stupid drum brakes) from right to left/left to right. The reason i'm thinking about doing this is to get my parking brake cables on the front side of the axle instead of hanging down low on the back side. Since the parking brake pull is on the lower/back side now, if i switch the plates around it will put them on the upper/front side of the axle. I know they will fit (because i've already taken them off and tried) but i'm just wondering if anyone knows of a problem that i'll run into down the road that i havn't thought of yet.

Thanks.
 
it looks like the only problem i may run into is my self adjusting parts. I'm going to swap them around so they will self adjust on reverse like they should instead of forward.

any input?
 
Back
Top Bottom