axle paint

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Spence

I did my frame with Por-15 and did my axles with Rustolium. I was worryed about rust on the frame but figured the axles won't rust though. Plus you got to get it really clean for Por-15... Rustolium is alot easier to deal with.

How'd the crossmembers work out?

Kevin
 
crossmembers

kevin they worked out great. got all the rivets out jsut waiting for my saginaw box then welding on spacers and to the sandblaster it goes!!!!
 
I Por-15'd my axles and frame, so far it has held up, as Toyo FJ40 stated, you nead to have everything impeccably clean for POR-15. I've used Zero-rust a bit (available through CCOT among other places), it's really easy to apply (spray cans) and looks good when done. I've heard a lot of good things about Rust-bullet(see the link on this site) as well as the Eastwood products( www.eastwoodcompany.com ) but have no experience with them, they may be worth checking out.
 
I cleaned and degreased both my axles recently during the rebuild. Wire wheeled everything. then hit it with probably 10 coats of high gloss black.

Theroy is the higher gloss wont allow mud, grease etc to stick to it very well. Kind of like why ovens and stoves are high gloss. they clean up easier.

plus the paint was 88 cents a can at wally mart.
 
I had Rust Bullet for my frame, but chose Eastwood Rust Encapsulator for the axles because it is BLACK and two easy coats did the job. Didnt have to top coat. I believe though not sure that it is cheaper than the other two.
 
A 2 part urethane coating would perform best. They will be far superior to enamels (rustoleum) when it comes to brake fluid, gas, abrasion, adhesion, etc.

The datasheet will tell you what to expect from the coating and how to best prepare the surface. There are standard tests that allow you to compare coatings.

I've used PPG CRE9xx. About $60 per gallon (3 quarts base + 1 quart activator). The datasheet is very impressive, and I've been satisfied with it.
 
1969cruzer said:
kevin did you use high gloss?

spence

I did high gloss on the axles and semigloss topcoat over the Por-15 on the frame.

Sparky_Mark's right about not holding up to brake fluid but I figured it's easy to touch up.

Por-15 will hold up to brake fluid but the top coat that they sell for going over it comes right off with brake fluid.

I did my rollbar with Por-15 and it came out like glass and is tough as nails. We'll see how it holds up to UV.

Kevin
 
Back
Top Bottom