Axel internal swaps

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 26, 2006
Threads
19
Messages
368
Location
Camp Hill, PA
Can the axels and center section from a 78 be swapped into the 66 housings? I have the monte carlo brakes on mine and the housings are nice. I heard the rear will fit but I havent heard anything on the front axel. The tech link on early to 78 just goes to a blank page, and everone in the search says their swapping the whole axel. If I cant keep the front axel can I still use my monte brake brackets(Original brake parts are pricey)
 
OK, but what about the rear? Will that fit or do I have to swap the whole thing?
 
Your right, it is ball and claw, but I didn't know if the housings were different. So what about the rear. Do they interchange or do I have to swap it too?
 
i would post in the fj25 forum the only thing differant about the two housing is the ball and claw housing uses a brass iner axel seal, where as the 78 housing uses a new ruber/spring seal. I think that the fj25 guys found a seal that would work for the swap.
 
OK, but what about the rear? Will that fit or do I have to swap the whole thing?

Yea, the guts can be swapped into the rear. The studs in the housing may be smaller than the holes in the differential. This did not cause me any problems in my 65. It has the original housing and later model diff and axle shafts.
PMK
 
Appreciate The Help. Sounds Like It Would Be Less Headache Down The Road If I Just Rebuilt And Swapped Both Axles In There Entirety. I Hoped For An Easy Swap But It Never Is.
 
Back
Top Bottom