Auxiliary Light Switch Install Question...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 17, 2016
Threads
74
Messages
270
Location
Portland, OR / SW WA
Hi, all!

I am going to install a pair of those round driving lamps on my ARB front bumper.

I have a question about creating a location for the light switch on my dash...

Would it work to put the switch where the diff lock switch would normally be on a locked 80? Could I just drill a hole in the plastic for the switch and run the wires through to connect it?

Here’s a picture of what the switch looks like:

3F8E9DFF-7ED1-4BA4-9D96-B43A73EB0F10.jpeg
220BCB80-32C6-49D7-86EA-9ED71682C8EB.jpeg
 
Yep. Either use that switch and drill the blank, or you can repurpose a Toyota switch in another blank hole.
 
  • Like
Reactions: mrq
The Toyota blanks are an easier replacement if you need to. The hand throttle plate and locker switch plate not so easy.
I would use the Toyota blanks
 
The Toyota blanks are an easier replacement if you need to. The hand throttle plate and locker switch plate not so easy.
I would use the Toyota blanks

Would this rear defrost switch work in place of the switch provided with my lamp kit? Would the wires that were supplied with the kit I have be able to be connected to this Toyota switch?

 
Would this rear defrost switch work in place of the switch provided with my lamp kit? Would the wires that were supplied with the kit I have be able to be connected to this Toyota switch?


Yes, that switch will work. You. need to use a relay, particularly if those lights are halogen lights.
 
Back
Top Bottom