Just picked up a new Autometer water temp guage and the none of the fitings worked on my Prado, any suggestions on a different guage or the possibility of another fitting and where I would go for this fitting.
Autometer mech water temp guage
- Thread starter RHD Toyota's
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #3
It's a 1991 LJ78 Prado
- Thread starter
- #4
Located in Fernie BC Canada
http://www.schaffersequipment.com/schaffers_equipment_services_overview.html
http://www.shopincanada.com/Business_Services/Industrial_Supplies/
Will the temperature probe on the a/m gauge fit where the original one fits? My replacement probe was too long to fit where the factory one was so I put it in the radiator hose.Its hard to help when you do not give any information what the problem is. If its a simple fitting to change the size check the local hydraulic hose shops. cheers
http://www.shopincanada.com/Business_Services/Industrial_Supplies/
Will the temperature probe on the a/m gauge fit where the original one fits? My replacement probe was too long to fit where the factory one was so I put it in the radiator hose.Its hard to help when you do not give any information what the problem is. If its a simple fitting to change the size check the local hydraulic hose shops. cheers
- Thread starter
- #7
the wrench sizes that were used on the fitings of my prado were 17mm and 19mm, The existing water temp sensor for the guage cluster was 17mm.