Autoenginuity OBD-2 PDA Scanner Question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 19, 2005
Threads
20
Messages
228
Location
Plano
Anyone out there (landtank maybe?) using the Autoenginuity OBD-2 Scanner for a Pocket PC? I have a PDA that I use for GPS and am thinking about using the bluetooth OBD-2 scanner feature these folks offer.

I'm wondering if anyone has a picture of the scaner plugged into the port so I can see how far this will stick out when its installed.

Thanks,
Ben
 
I'm wondering if anyone has a picture of the scaner plugged into the port so I can see how far this will stick out when its installed.

The ScanGuage-II guys are doing a mod on their OBD-II connector so that it points in another direction, giving room for the plug to stay attached with the fuse panel cover on.

There are pics in those threads.

-B-
 
I have the Autoenginuity & the Scangauge. The Autoenginuity sticks out quite a bit. I'd guess 6 or a little more inches with the blue tooth adapter. The Scangauge is much closer -- it sticks out enough you can't put the cover on, but not by much.

The Autoenginuity gives much more detail for the typical ODBII readings (MAF, O2 sensor output, LTFT, STFT, etc.)

The Scangauge shows MPG that is surprisingly accurate, and is nice for monitoring open/close loop, water temps, MPG, voltage, and some others in realtime as you're driving around. It is missing some key ODBII info, though (fuel trim, MAF rates, and a few others).

Neither shows transmission fluid temperature. The scangauge folks claim to be "working on it", though.
 
Thanks. My concern is that the autoenginuity scanner with bluetooth adaptor would stick out of the fuse panel too far to leave in full time. Sounds like it will. Looks like scanguage may be the ticket.

Ben
 
Back
Top Bottom