Arb/M12000 Install, Control Box Orientation?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 1, 2004
Threads
32
Messages
302
Location
austin, tx
I bought an arb today and m12000 from Wimberly Four Wheel Drive down here in Texas. Anyways, the instructions are HORRIBLE and incredibly vague. I have a few questions, but my primary reason for this thread is the location and orientation of the control box. I have read most people mount it on the motor, but the only way it seems it will fit is directly upwards where it is clearly visible. I have never seen a box just sticking up there. It seems if I mount it any other way it will not be accessable.

So, which way should I orient the control box?

What should I torque mounting bolts for winch to? Frame?

Thanks, William.
 
Can on I know someone with an arb and m12000 has seen this... bump.
 
There is a bracket that attaches to the bottom of the solenoid box and raises it up about 1.5" That bracket is clamped to the motor with the big hose clamps that are supplied with the winch.

The bracket has a long "finger" and then a 90 degree turn and then a hex shaped mounting plate with some holes in it. The side with the holes bolts to the bottom of the control box. You have to open the control box and you use the small 1/2" bolts (or 6mm not sure) that is supplied with the bumper

The control bos sits on top of the motor, tilted slightly backwards. Unless you extend the wires from the control box to winch, this is the only place it will fit.
 
Do you put the bottom of the control box back on? What exactly does the hex thing bolt to?
 
Two of the bolt holes in the hex plate should mate up with two mounting holes in the bottom of the box. Screw the hex plate bracket to the box, then clamp the whole thing onto winch the cylinder with the hose clamps, as Christo said.

HTH,
 
I just installed my control box tonight (M12000) and didn't use the hex plate that came with the ARB I just didn't see the need for it. The box mounted perfectly to the motor with the hose clamps tilted back a bit with a lower profile than with the mounting plate. Is there really a need for it?
 
Mine is on top of the motor, held with hose clamps (that I lined with tape to avoid scrapes). Readily accessible. Only con in my mind is partial blockage of the grille. Of course, I don't keep the box hot to prevent taco problems :).
 
Mine is on top of the motor, held with hose clamps (that I lined with tape to avoid scrapes). Readily accessible. Only con in my mind is partial blockage of the grille. Of course, I don't keep the box hot to prevent taco problems :).
Mine sits just below the grill no blockage at all but I know my Lightforce 240's are going to block the grill a considerable amount but I think it will be fine. Did you install a solenoid so you can switch off the control box power?
 
I just installed my control box tonight (M12000) and didn't use the hex plate that came with the ARB I just didn't see the need for it. The box mounted perfectly to the motor with the hose clamps tilted back a bit with a lower profile than with the mounting plate.

Exactly how ours is mounted also. No problems here.

 
Exactly how ours is mounted also. No problems here.

Yup, looks just like my install. Like I said, why would you need the hex plate must be for some other application.
 
Back
Top Bottom