Any tips for removing a dash?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 13, 2007
Threads
108
Messages
479
Location
Arizona
Any idea on how to keep everything organized and together? I need to take off my dash to try and find a AC leak and a short in my cluster. The AT TEMP, BRAKE and BATT light all three flicker on and off together,
 
zip-lock baggies, and a sharpie. Label the baggies as you remove the hardware.

If extra confusing put some masking tape on some dash peices and label what hardware needs to go back there.


everytime I mess with the dash I end up with extra hardware. I'm not entirely sure what is holding the thing together right now :o
 
There's not very many pieces actually. The two large dash pieces (upper and lower) and lots of screws. I've found a lot of the screws are interchangeable so its not a big deal. Finding all the screws you need to remove is kinda a pain, just look from lots of different angles and there are like 5 holding the ashtray in that have to go.
 
Ok I have the manual to follow. I think I tape the screws down as I pull them out. Hopefully I can find my AC leak.
 
Once you find the leak, even if you dont fix it yourself you saved a bunch by dismantling and locating it yourself. Best of luck, you'll be fine
 
Great, not sure if that is good news or bad.
 
I took apart my dash on the weekend, maybe one of the first times it's been apart and best I can describe it is it's like a road map, never goes back together properly. I have a gap in my lower dash now that makes no sense. Everything came out, everything went back in, I was carefull with what went wear and there is stll a gap that I can't get closed up.
 
I just laugh now. Today I found out I may need a new alternator too. So the list currently stands at AC, Power Stearing gear box, BIRFS and myabe a alternator. Hate to say it but she may get rolled into a dealership late one night the last day of the month. the good thing is she is clean as a whistle inside and out. I think I may start to tackle one job at a time and see how it goes. Who kows maybe one day I'll drive her more than a 100 miles at a time. I have put a whooping 3,000 miles on here in 10 months of ownership.
 
Last edited:
I just laugh now. Today I found out I may need a new alternator too. So the list currently stands at AC, Power Stearing gear box, BIRFS and myabe a alternator. Hate to say it but she may get rolled into a dealership late one night the last day of the month. the good thing is she is clean as a whistle inside and out. I think I may start to tackle one job at a time and see how it goes. Who kows maybe one day I'll drive. I have put a whooping 3,000 miles on here in 10 months of ownership.

I feel your pain. All I can say is








dibs on your Kaymar.
 
LOL Everyone wants the Kaymar. It's the low budget OEM bumper bolt on. But a rear tire carrier none the less.
 
Anyway...

To help you along:

Lower dash (below steering wheel) - 4 screws
Upper dash (above steering wheel) - 3 screws and a lot of electrical connections
Glovebox - 2 screws
 
Back
Top Bottom