Any solutions to fill "hole" when 3rd row seats removed?

[Sirrattles]

Hello,
Wondering if anyone has a source for 3D printed cargo tie-downs to fill the holes left when removing the 3rd row seats (2016 200 Series truck). I have sent several messages via their website and direct to s3dp.com.au but no response. Thanks.

 

[steelsparky]

Just throwing out the only thing I know about, you do need to buy the print though. You could add d-ring tie downs under the bolt on this one I'd assume.

https://cults3d.com/en/3d-model/tool/zaglushki-3-ryada-sideniy-land-cruiser-200-lexus-lx570

If you don't have access to a printer you could get the job done quickly on reddit, r/3dprintmything.

 

[Sirrattles]

Thanks for the info. Way outside my area to try that ... LOLOL.

 

[Sandroad]

I like the s3dp tie downs best and it did take a bit for an email response. Have you looked at the Kaon version?

Rear Seat Delete Tie Down Points to suit Toyota LandCruiser LC200

Rear Seat Delete Mounting Points to suit Toyota LandCruiser LC200 - KAON

www.kaon.com.au

 

[Sirrattles]

I had not seen the Kaon version. Thanks!!

 

[Sirrattles]

Just ordered these.......

https://www.etsy.com/listing/4437967352/lx570lc200-3rd-row-seat-delete-trim?gpla=1&gao=1&utm_source=connexity&utm_medium=cpc&utm_campaign=shopping_us_bing&utm_content=26f5ba192f3911858bb5d020f413362d&msclkid=26f5ba192f3911858bb5d020f413362d&utm_term=4585100935165949&variation0=6194894582