Another front end clunk thread...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 26, 2005
Threads
36
Messages
239
Location
Highland, UT
I've done the search, but there doesn't seem to be a thread that specifies the same clunk.

I have recently started getting a clunk when turning to either side. It happens almost always when nearing/leaving full lock. I initially thought it was my rod ends, and thought after replacing them last week the clunk had gone away. But, today, I re-discovered it. I had my son turn the wheel for me so I could try to pinpoint the location, and it seems to be coming from inside the axle housing. I can feel the clunk at the DS hub while my hand is on the grease cap. I could also feel it clunking with my hand on the front diff.

I did a complete birf job about 1500 miles ago and the birfs looked good (to my untrained eye), although I didn't pull the birfs apart. The truck also drives fine, with no clicking or other noises except for the clunk at each end of the steering spectrum.

Any ideas on this? I would hope to not tear into the knuckles again, but I'm afraid that might be needed. Any input is most appreciated.
 
Did you happen to replace your Trunion bearings when you did your birfs? That's what it sounds like to me...

(Note: trunion bearings are what the knuckles pivots on when you turn.)

what he said. also, do you have a lift installed? i installed my slee 4" and i had to go under and and tr-tighten the bolts. specifically the front panhard rod and the front control arms. that got rid of the clunk for me.
 
Did a complete rebuild of the knuckles, including trunion bearings/races. Also just checked the hubs and everything is still to spec. I've also just installed f/r panhard adjusters and replaced all four tie rod ends so I know those bolts are tight.

I'll double check the knuckle arms and trunion flanges to make sure they haven't come loose. Oh, and I have a 4" comp lift with Slee plates. I'll check the control arms as well.
 
Last edited:
I crawled under the truck and tightened everything on the front end. Trunion flange/knuckle arm bolts were still torqued to spec. Found that the upper DS bolt holding Slee's plates on was a bit loose, and I was able to get a bit more out of all the control arm bolts as well as the upper panhard bolt. Clunk seems to be gone! :bounce:

Thanks for your input guys. I would have put money on it being internal...glad it's not. For anyone else having the same issues, tighten those control arm/panhard rod bolts as tight as you can get them.
 
Back
Top Bottom