Another front bumper question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 2, 2004
Threads
71
Messages
390
Location
Raleigh, NC (Outside the Beltline!!)
Since I'm missing the front triangular style bumper hangers and the guy that is fabbing up the bumper wants to double check his measurements, can somebody on here measure where the holes are to be placed using stock front bumper hangers.

I plan on using the stock hangers if I can find them. Anybody got a set?

I think there are four mounting holes so if somebody could give me center to center measurements accross, I would appreciate it.

Thanks,
Chad
 
Ok, you ready Freddy?? At the "base" of the triangle you will have an OUTSIDE measurement of 8 1/4"......the holes to mount the bumper are 7/16" holes.......going left to right your measurements to CENTER are.....11/16" and then 2 3/8".......then measure from right to left with same measurements and you will have your other holes. You then have a 3/8" hole in the center of your triangle that is 3 9/16" to center from the "base" running to the "peak", cntered left to right of your overall width..8 1/4" = 4 1/8". Then come the two Tow-Hook holes at the top....also located at 4 1/8" left to right which is the center of your triangle, now for the measurement up from the "base" towards the "peak" to center and these are 1/2" holes BTW......6 11/16" and the second one is 8 1/16"....sounds confusing , but I hope it makes sense if you read carefully!! Hit me back with any other Q's!! Good luck!! :cheers:
 
If your talking about the brackets that bolt to the outside of the frame I got mine from Cruiser Solutions $50 for a set FOB Reno. Way cheaper than I would pay to have them made. I believe they have the triangle part as well.
 
Back
Top Bottom