Ambulance Door Header Removal

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 1, 2002
Threads
55
Messages
259
Location
Peachland, BC, Canada
Website
members.sounddomain.com
I'm planning on changing out my ambulance doors with a rear hatch system. From what I understand, the stock header on the hardtop has to be removed and replaced with one from a hatch hardtop.

What it involved in removing the header? Is this a simple couple bolts or will the fiberglass topper, metal rain gutters etc have to be taken off?

Also, does anyone have any pictures/measurements of where the lift struts are bolted onto the hardtop?

Thanks in advance!
 
the angled pieces in the corner have to be unbolted, and, as mentioned, there are bolts that go in from the top...if you feel up in the inside of the rain gutter you'll feel them...expect them to break.
 
I am looking to do the exact same thing. I took mine apart already...The header came off really easy. Mine had a rubber pad at each end of the header that was attached with clips. The 2 top bolts kind of suck because you need to unbolt the fiberglass to the post to get it it to lift enough to get a wrench on it. The whole thing came apart way easier than I expected. Let me know how it goes.
 
All you have to do is remove the 3-4 screws inside that bolt down from the cap to the header (you can do this with a swivel socket or small socket. No need to remove the cap. Then all you need to remove is the 4 phillips screws that go from the header into the sides of the hardtop. It should all come out at that point. I have done this a number of times.
 
Back
Top Bottom