alternator install.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 9, 2004
Threads
101
Messages
1,454
Location
The West
ok i will be installin g my 3rd alternator because all of the other ones have failed..... long story i took mine apart noob style in plans of cleaning it up visually ...lol anyways i baught a bosh alternator from like a parts warehouse just two days ago. it has a little warning tag stating that if the battery is not fully charged and i install the alternator it could fail to work... i have been driving her for 2 dayz prior to failing of the third alternator ( used) and the bat could not make her turn over any more.


is this true or a bunch of bs because i do not ahve access to a volometer or the freakin money to get one.. just need some answers fast i wanna hook er up!

:bounce2:
 
I call BS, just hook it up and run it.

now if it dies.............don't tell em your battery was low :D
 
haha ok! how will they know....
 
If the battery does not have 12V possible, then the alternator may not get the required signal voltage to excite the field and work properly, which if you do not know what you are looking for, would make you think that the alternator is not working properly.....



Along the same lines, if you install a good alternator into a poorly functioning electrical system, ie, bad battery, poor wiring/connections at the battery, etc. it may make the alternator try and work harder than it needs to, and possibly cook itself.




Have seen both of these scenarios.



Have you verified the operation of your voltage regulator?
 
voltage regulator is brand new
 
okie said:
voltage regulator is brand new




Is there continuity in the wiring between the alternator and the voltage regulator? ;)



New or used makes no difference if it is not in the loop, doing its job.
 
Ron Diaz of custom cruisers just replaced it 2 dayz ago. I think he did it right otherwise i wouldn't know just from looking at it.

y are you asking?
 
ok so i just finished the alternator install and also got my bat recharged

well i took it for a test drive to amke sure everything is ok. i tightened the belt. hooked everything up properly.. nothing i swrong except...

whenever i accelerate just a little hard ) half throttle and more) there is a high pitch whistle. not screeming loud but sounds kinda funny. any chance it would maybe be the aircleaner gasket that has a leak

6/70 fj40.

thanx

rachel
 
loose belt I would say
 
yup thats what i said but i checked it doiuble and its pretty tight.

it jsut squeals when i accelerate kinda hard.
 
OK......to tight? but really it sounds like its too loose to me.........

okie said:
yup thats what i said but i checked it doiuble and its pretty tight.

it jsut squeals when i accelerate kinda hard.
 
Are you positive that the belt is the issue?


Will it make the same noise while increasing the engine RPM's while stationary/truck not rolling down the road?
 
Back
Top Bottom