Hey all, I searched but came up empty. I just used techstream to check my ahc pressures. I adjusted the torsion bars then ran techstream again. I played around with the solenoid tests and then my AHC flashed off. I can't figure out how to turn it back on if thats possible. All I did was run the program, adjust the bars and run the solenoid tests. Any ideas?
Navigation
Install the app
How to install the app on iOS
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
More options
Style variation
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
AHC off via Techstream
- Thread starter BradP
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #2
Nevermind, I found a post with the same problem and I had inadvertently pushed the off button. Completely forgot it was there. Worst First Post ever lol.