After Re-Gear Fluid Swap...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 10, 2005
Threads
360
Messages
4,040
Location
КАГІҒОЯИІА
Going to drop off the beast for her 4:88 regear sometime in the next week.

Wondering if I should have the guy doing it put synthetic back in right away or run some cheap dino for a few hundred miles, swap it out a few times, for metal shavings from the new gears, and then put the spendy syn in...

What do you folks think?
 
Can't hurt.
 
Do the cheap stuff. Get a 5 gallon bucket of 80w90 and swap out with each oil change. Make it a part of your regular maintenance of changing fluids...

Unless, of course, you are paying extra for the synthetic stuff. Then, I'd do a few hundred miles (~500) with the cheaps stuff and swap it out a few times over the course of a 1000 or so miles (after the gear swap), then switch to the synthetic stuff.

Personally, the cheap stuff works fine in my book for all LC applications.

-o-
 
You are going to drop the fluid after the first 500 miles anyway, so don't put expensive fluids in there. Just use some 80w-90 and call it good. I mostly use Coastal 80w-90 in all my diffs. It's pretty cheap in the 5 gallon bucket.

If you want, just use some Valvoline. Every diff shop I've been in (all 2 of them!) have big bulk containers of Valvoline. It's a little more than Coastal, but it meets the specs and will serve you just fine, and you won't feel bad using cheap gear oil.

After 500 miles, run synthetics if you wish, but at $10 per quart, it's hard to justify, especially when you realize that every time you are in significant water, you *should* change the diff oil.
 
Back
Top Bottom