Adjusting Idle

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 12, 2007
Threads
90
Messages
2,104
Location
Gilbert, AZ
I have the TIS manual, but there doesn't seem to be anything on how to adjust the idle. Searched around here too and not much help. The PO did a wonderful job of trashing the throttle cable and timing, so I am starting from scratch. Any advice?
 
I don't think there really is an idle adjustment, per se.

For example, there's a big flat head screw on the front of the throttle body that will temporarily raise the idle when unscrewed a bit, but after a few drive cycles the computer usually brings the idle back down to where it was previously.

Better to just make sure all the cable linkages, dashpot, TPS, etc. are adjusted to spec.

Curtis
 
I'd love someone more intelligent than me to chime in. I've read alot about adjusting the timing to get better 'off the line' performance. There is a section in the FSM and my Haynes manual, but I've been told repeatedly that I could screw-up the engine if I do this wrong - so I've stayed away for now.

I'm hoping someone has a nice easy answer!
 
Back
Top Bottom